View source for IMU Digital Combo Board-6DOF ADXL345 and ITG3205

==Introduction==
[[File:6DOF.jpg|250px]]

This product is a simple breakout for the ADXL345 accelerometer and the ITG-3205 gyro. You get a full 6 degrees of freedom With this board. The sensors communicate over I2C and one INT output pin from each sensor is broken out. If you need a simple and tiny board that gives you 6 degrees of freedom, this would be a good choice.


==Features==
*Tiny
*ADXL345 accelerometer
*ITG-3205 gyro
*3.3V input
*2C interface

==Document==
[http://www.geeetech.com/Documents/ADXL345%20Datasheet.pdf ADXL345 accelerometer datasheet]

[http://www.geeetech.com/Documents/ITG-3205-00-01.4.pdf ITG3205 Gyro datasheet]

==Usage==
Here is a guide illustrates how to connect an IMU 6DOF board to Arduino. The following is a table describe which pins on the Arduino should be connected to the IMU 6DOF board.

[[File:6 DOF wiring.jpg|400px]]

 VCC -> 3.3V
 GND -> GND
 SDA -> A4
 SCL -> A5
==Example code==
[http://www.geeetech.com/Documents/6DOF%20example%20code.rar IMU 6 DOF Combo Board Example code]

==How to buy==
Click here to buy [http://www.geeetech.com/mu-digital-combo-board6dof-adxl345-and-itg3205-p-538.html IMU Digital Combo Board-6DOF ADXL345 and ITG3205]