GT2560A/GT2560A+: Difference between revisions

From Geeetech Wiki
Jump to navigation Jump to search
← Older editNewer edit →
Line 1: Line 1:
==Features==
==Introduction==


1.Integrated with the mighty function of the Arduino Mega2560+Ultimaker and Arduino
GT2560 is a compact board that is integrated with the mighty function of the Arduino Mega25
Mega2560+ramps 1.4 kit, The GT2560 can not only take full place the them on respect of both
60+Ultimaker and Arduino Mega2560+ramps 1.4 on respect of both software and hardware and has
software and hardware, but also features compact size, more convenient connection, and more
more premium features: the streamlined interfaces effectively avoid the unnecessary troubles, wellregulated
stable.
compaction of components highly integrated saves more space and easier to be mounted o
2. Adopt ATmega2560 as the main control chip, coupled with the high-performance USB serial
n most applications.
converter FT232RQ.
5 stepper motors, swappable driving modules, mighty ATmega2560 processor with 256k mem
3. The power pack: operating voltage is 12V-24V; double power supply design feeds for
ory, 16MHz operating frequency, high-performance USB serial converter FT232RQ, all these make
heatbed and logical part separately. The current is 15A for heatbed and 10A for other parts.
the GT2560 an ideal option for a 3D printer control board. What’s more, GT2560 can run over 12V
4. The main circuit adopts SMD fuse tube, the diode added to the power port can provide
to 24V which gives higher torque and higher rotation rate.
reverse protection to the whole circuit, in addition, the 5V USB is USB port protected with 500mA
Recoverable fuse.
5． 3 12v fan output and one PWM output for LED or other lighting equipment.
GEEETECH
www.geeetech.com Tel: +86 755 2658 4110 Fax: +86 755 2658 4074 -858
- 4 -
6. 3 55Amp MOSFET (with LED indicator, the actual output is restricted by the PCB board
and the connector), all 3 MOSFET are equipped with heat sink to ensure sufficient heat dissipation
and stable operation.
7. Support 5 A4988 stepper drivers (3 for X/Y/Z axis, and 2 for extruders); the subdivision of
stepper motor can be setup by dial switch, eliminating jumper caps, easier to operate.
8. 3 temperature sensor input (100k thermistor is recommended)
9. Extended LCD and SD card interface support both LCD2004 and LCD 12864, with which
you can print without your PC.
10. The firmware is the prevalent Marlin, which is known for stability, usability, and
high-performance.

Revision as of 10:41, 4 May 2018

Introduction

GT2560 is a compact board that is integrated with the mighty function of the Arduino Mega25 60+Ultimaker and Arduino Mega2560+ramps 1.4 on respect of both software and hardware and has more premium features: the streamlined interfaces effectively avoid the unnecessary troubles, wellregulated compaction of components highly integrated saves more space and easier to be mounted o n most applications. 5 stepper motors, swappable driving modules, mighty ATmega2560 processor with 256k mem ory, 16MHz operating frequency, high-performance USB serial converter FT232RQ, all these make the GT2560 an ideal option for a 3D printer control board. What’s more, GT2560 can run over 12V to 24V which gives higher torque and higher rotation rate.

Retrieved from "https://wiki.geeetech.com/index.php?title=GT2560A/GT2560A%2B&oldid=8258"